Architectural
Building System Solutions

Profiles bending

  • Technological limitations:

- maximum arc total height 2100 mm
- maximum arc total height for wood grain colour 1700 mm
- there are minimum bending radius for the individual profiles - see table above
- realization of arcs below the minimum bending radius upon the basis of the customer's written consent - in such case the quality is not
assured
- in case of glazing selection for the arc connections below the bending radius of 900 mm it is required to take the additional clearance of
2 mm into consideration
- the arc length with the technological allowances must not exceed the factory length of the profile
July 2018
Str. - 10 -
- in case of bent facade beams and columns the maximum arc length having assured quality is 3000 mm
- the minimum technological allowance is 800 mm
- we do not realize orders for bent profiles in bicolour: wood grain colour + RAL

  • Optimization:

- Alicad software does not optimize the number of arcs nor the material amount required for realization of arcs
- the optimization of number of arcs is the orderer's responsibility
- if there is a possibility of connecting the multiple arcs into one of larger length, it should be included in the order
- the optimization of material amount required for realization of arcs is Aliplast company responsibility
- the waste material from bending arcs belong to the customer and are delivered with the arcs
- the waste material from bending arcs are not suitable for use as straight segments

  • Additional information:

- the arcs are the non-system solutions
- deviations from the nominal profile dimensions are unavoidable. The deviation type and range depend on the bending radius, profile
type, and wall thickness
- for arcs bent according to the templates we also assume deviations up to 10 mm from the upper arc edge
- in case of welded connections we assure the quality of the visible surfaces
Identification of realized products (arcs):
- glazing beads - there are the Aliplast order number + structure number according to the orderer's documentation stamped on the inside
of the decorative surface
- main profiles - there are the Aliplast order number + structure number according to the orderer's documentation stamped on the
outside of the decorative surface
- the numeric designation is placed on the technological waste as low as possible

Please find the Price List for banding profiles in Authorisation zone

Aliplast profile bending

The website uses cookies to provide services in accordance with privacy policy . You can specify the conditions for storage or access to cookies in your browser or service configuration.